Brochure
Water Jets
43
Nozzles
Whether you’re up against grease,
sand, or ice, there’s a General nozzle
that will cut through it. Some are
designed for maximum penetrating
power, some are designed to pressure
wash the pipe walls, and some are
designed to go around sharp bends.
All of General’s nozzles are made of
hardened stainless steel to last longer.
Rotary Nozzles
Make sure you leave the
lines crystal clear with
General’s rotary nozzles.
The JN-RB heavy duty
hardened stainless steel rotary nozzles have two 90 degree jets
to scour the walls of the pipe, and two 35 degree jets to drive
the hose down the line. The less expensive JN-RA hardened
steel rotary nozzles have two 45 degree jets for combined thrust
and cleaning action.
High Performance Nozzles
General’s High Performance Nozzles
incorporate patented fluid mechanics
that significantly increase thrust, pulling power, and cleaning
power without needing to increase water flow or pressure.
These nozzles are custom machined to redirect the water
through highly efficient inner surface channels directed toward
each orifice. The nozzles have replaceable threaded inserts at
each orifice, so when the nozzle wears, you only have to replace
the inserts, not the whole nozzle.
Hoses
Tough high pressure jetting
hose comes in a variety of lengths and diameters. Use the 1/2"
ID hose for main lines and long runs at distances up to 400 ft.
Use the 3/8" ID hose for clean outs, 4" through 8" floor drains,
and septic lines at distances up to 300 ft. With the 1/4" ID
hose, you can clear 2" through 4" lines up to 200 ft. away. And
the Super-Flex™ 1/8" hose has the flexibility to get through
1-1/2" and 2" lines and bends up to 75 ft. down the line.
Powerful penetrating nozzle cuts
through grease and ice.
Wide spray flushing nozzle cleans inside of
pipe thoroughly.
Downhead
nozzle takes
hose down tees and around difficult corners.
Spring Leader nozzle helps guide
hose around tight bends and
P-traps.
Jet-Set Nozzles and Hoses
®
n3/8" nozzle is available in
4, 5.5, and 8 gpm models
to clear 4", 6",
and 8" lines.
Chain Saw Nozzle™
Rip through roots with the Chain Saw Nozzle.
Lengths of chain can quickly and easily be switched for
different diameter
pipes. Spins at up
to 10,000 RPM
n 1/2" nozzle works well in
combination with the 12 gpm
Typhoon trailer jet to clear
4", 6", 8", and 10" lines.