Brochure

24
Here’s a sectional cable machine that drives 7/8" and 5/8"
sections – or even 5/16" cables for small drain work. You
switch from 7/8" to 5/8" and back by repositioning the chuck
cone. No adapter required. Attach a small drum to the back of
the machine to drive smaller cables.
The I-95 gives you power and convenience. The motor is a
1/3 hp capacitor type, so it delivers plenty of torque to the
cables. Yet, as soon as you lift the drive handle, the cable
stops rotating, so there’s no additional torque build up.
You also use the drive handle to carry the machine. And
when it’s in position on the job, its four point base gives it
rock-solid stability. A cutter holder is attached to the back
of the I-95, so your cutting heads are always with the
machine. A Ground Fault Circuit Interrupter is standard
equipment.
Clear
1-1/2" – 2"
lines with
5/16" x 25'
cable.
Specifications:
Weight:
39 lbs. (18 kg).
Dimensions:
16" deep; 14" wide; 17" high (41 cm x 35 cm x 43 cm).
Motor:
1/3 hp capacitor type with forward-off-reverse switch, ten-foot
power cord, and Ground Fault Circuit Interrupter. Rotates cables
at 400 rpm.
Adjustable Chuck:
Has two sets of notches; one for 5/8" cables and one for 7/8"
cables. Switch from one to the other in seconds. Pull down
handle to engage, lift to stop. Brake stops spinning drums
instantly. Chuck handle also acts as lifting handle.
Chuck Jaws:
Drive both 5/8" and 7/8" cables; also grip drum for smaller diameter
cables.
Drum:
Drum holds 25 ft. x 5/16" cable for 1-1/2" to 2" lines, or 35 ft. x 3/8"
cable for 2" to 3" lines.
Leather Gloves:
With double-reinforced palm, for hand protection when guiding cable.
Cables: See page 32.
Cutter Sets: See page 30.
Clear 2" – 3" lines up to 125 feet long
with 5/8" x 7-1/2' sections or 4" lines up to
150 feet long with 7/8" x 15' sections.
I-95
It’s Three Machines in One
®
I-95 and
Root 66
Accessories