Instruction Manual

Document # GP-IN-MDL-003-CONTROLB-12 Page 13 of 13
14351 Pipeline Ave., Chino, CA 91710 • Tel: [phone] • Fax: [phone]
Website:
www.lunainc.com
Email: [e-mail]
Dial setting Clock pulse frequency
0 16 Hz
1 31 Hz
2 63 Hz
3 125 Hz
4 250 Hz
5 500 Hz
6 1000 Hz
7 2000 Hz
8 N/A
9 N/A
Forward button: MDL moves in the direction of increasing delay, at a speed
determined by the speed selection dial and step mode settings, as long as
the button is held down. When it reaches the maximum delay, it stops, and
holding down the button has no further effect.
Reverse button: MDL moves in the direction of decreasing delay, at a speed
determined by the speed selection dial and step mode settings, as long as
the button is held down. When it reaches the minimum delay, it stops, and
holding down the button has no further effect.
Section 6. Technical Support
General Photonics is committed to high quality standards and customer satisfaction. For
any questions regarding the stepper motor control board, please contact us at (909)-
590-5473 (telephone) or (909)-902-5536 (fax), or by e-mail at
[e-mail]
. We
will respond to all customer questions within 24 hours during regular business hours.
You can also contact us by mail at:
General Photonics
14351 Pipeline Avenue
Chino, California 91710
USA