Specification Sheet

GENERAL FINISHES
PO Box 510567 New Berlin, WI 53151 800-783-6050
NOTICE: All of the above statements, recommendations, suggestions, and data concerning the subject material are based on laboratory results and
believed to be reliable. We expressly do not represent, warrant, or guarantee the accuracy, completeness or reliability of same, or the material or
the results to be obtained from the use thereof, neither do we warrant that any such use, either alone or in combination with other materials shall be
free of the rightful claim of any third party by way of INFRINGEMENT or the like and (THE MANUFACTURER DISCLAIMS ALL
WARRANTIES, EXPRESSED OR IMPLIED,) OF MERCHANTABILITY and FITNESS FOR A PARTICLUAR PURPOSE.
Mixing and Application:
Catalyst Ratio: None
Pot Life: Not Applicable
Shelf Life: 1 year, minimum
Reducer/Thinner: EF Extender (10 -20%)
Sealer & Finish Recommendation:
Can be topcoated with most water base, oil base, and sol-
vent base finishes, varnishes, & lacquers. Compatible
with all General Finishes topcoats. Test adhesion and
compatibility on all other systems.
General Finishes Sanding Sealer recommended if not us-
ing a self sealing finish or optimum build and smoothness
is desired. Use: Water Base: Pro-Series, PolyAcrylic, High
Performance, or Pre-Cat 181. Oil Base: General Finishes
Arm-R-Seal. Solvent Base: General Finishes Pre-Cat Lac-
quer or Conversion Varnish.
Surface Preparation:
Surface must be clean, dry and free of dust, dirt, grease,
wax, or contaminants. For Raw wood, start sanding with
#120 grit & finish with #180 -#220. Fill all nail holes or
cracks using a water base filler or putty. Remove all dust
by vacuuming or wiping with a damp cloth. Do not use
tack cloths which contain linseed oils.
Application:
Conventional Spray:
Air Assisted Airless
HVLP
Brush
Pad Applicator
Cautions:
Mix container before use
Protect from freezing
Read MSDS for safety information
Clean-up Information:
For best results, clean all equipment
with General Finishes Brush and Gun
Cleaner. General clean-up with soap
and water recommended. Rinse
thoroughly with clean water.
General Finishes Glaze Effects
1216055