Specification Sheet

ManualsBrandsGeneral Finishes ManualsHome Decor1 Quart Interior RTM (Ready To Match) Water Base Wood Stain

The industry leader in water based technology.

NOTICE: All of the above statements, recommendations, suggestions, and data concerning the subject material are based on laboratory results and

believed to be reliable. We expressly do not represent, warrant, or guarantee the accuracy, completeness or reliability of same, or the material or

the results to be obtained from the use thereof, neither do we warrant that any such use, either alone or in combination with other materials shall be

free of the rightful claim of any third party by way of INFRINGEMENT or the like and (THE MANUFACTURER DISCLAIMS ALL

WARRANTIES, EXPRESSED OR IMPLIED,) OF MERCHANTABILITY and FITNESS FOR A PARTICLUAR PURPOSE.

Mixing and Application:

Catalyst Ratio: None

Pot Life: Not Applicable

Shelf Life: 1 year, minimum

Reducer/Thinner: EF Extender (10 -20%) if necessary

Sealer & Finish Recommendation:

Can be topcoated with most water base, oil base, and sol-

vent base finishes, varnishes, & lacquers. Compatible

with all General Finishes topcoats. Test adhesion and

compatibility on all other systems. Color will vary depend-

ant upon wood, degree of sanding, and dwell time before

wiping.

General Finishes Sanding Sealers are recommended if not

using a self sealing finish for optimum build and smooth-

ness. Topcoats: Water Base: PolyAcrylic, High Perform-

ance, Enduro Water Base Lacquer, Enduro Poly, Pre-Cat

Urethane or EnduroVar. Oil Base: General Finishes Arm-

R-Seal or GF Gel Stain. Solvent Base: Most pre-catalyzed

lacquers and conversion varnishes (check adhesion).

Surface Preparation:

Surface must be clean, dry and free of dust, dirt, grease,

wax, or contaminants. Raw wood, sanding with #150 grit

recommended. Fill all nail holes or cracks using a water

base filler or putty. Remove all dust by vacuuming or wip-

ing with a damp cloth. Do not use tack cloths which con-

tain linseed oils.

Application:

 Conventional Spray:

 Air Assisted Airless

 HVLP

 Brush

 Pad Applicator

Cautions:

 Mix container before use

 Protect from freezing

 Read MSDS for safety information

 Clean-up Information:

For best results, clean all equipment

with General Finishes Brush and Gun

Cleaner. General clean-up with soap

and water recommended. Rinse

thoroughly with clean water.

RTM Water Base Wood

Stains 041311