Safety Data Sheet - Red

ManualsBrandsGeneral Finishes ManualsHome Decor1 Quart Interior RTM (Ready To Match) Water Base Wood Stain

RTM Red

N-methyl-2-pyrrolidone

AIHA WEEL (United States, 10/2011). Absorbed

through skin.

TWA: 10 ppm 8 hours.

Section 8. Exposure controls/personal protection

Ingredient name

Exposure limits

Hand protection

Use a properly fitted, air-purifying or supplied air respirator complying with an approved

standard if a risk assessment indicates this is necessary. Respirator selection must be

based on known or anticipated exposure levels, the hazards of the product and the safe

working limits of the selected respirator.

Chemical-resistant, impervious gloves complying with an approved standard should be

worn at all times when handling chemical products if a risk assessment indicates this is

necessary. Considering the parameters specified by the glove manufacturer, check

during use that the gloves are still retaining their protective properties. It should be

noted that the time to breakthrough for any glove material may be different for different

glove manufacturers. In the case of mixtures, consisting of several substances, the

protection time of the gloves cannot be accurately estimated.

Safety eyewear complying with an approved standard should be used when a risk

assessment indicates this is necessary to avoid exposure to liquid splashes, mists,

gases or dusts. If contact is possible, the following protection should be worn, unless

the assessment indicates a higher degree of protection: safety glasses with side-

shields.

Eye/face protection

Respiratory protection

Body protection

Personal protective equipment for the body should be selected based on the task being

performed and the risks involved and should be approved by a specialist before

handling this product.

Environmental exposure

controls

Emissions from ventilation or work process equipment should be checked to ensure

they comply with the requirements of environmental protection legislation.

Appropriate engineering

controls

Good general ventilation should be sufficient to control worker exposure to airborne

contaminants.

Wash hands, forearms and face thoroughly after handling chemical products, before

eating, smoking and using the lavatory and at the end of the working period.

Appropriate techniques should be used to remove potentially contaminated clothing.

Contaminated work clothing should not be allowed out of the workplace. Wash

contaminated clothing before reusing. Ensure that eyewash stations and safety

showers are close to the workstation location.

Hygiene measures

Control parameters

Individual protection measures

Occupational exposure limits

Skin protection

Other skin protection

Appropriate footwear and any additional skin protection measures should be selected

based on the task being performed and the risks involved and should be approved by a

specialist before handling this product.

Section 9. Physical and chemical properties

Physical state

Liquid.

None

Odor

Red.

Color

Not available.

Odor threshold

: 8.4

Appearance

5/11

Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)