Safety Data Sheet - Raw Umber

ManualsBrandsGeneral Finishes ManualsHome Decor1 Quart Interior RTM (Ready To Match) Water Base Wood Stain

RTM Raw Umber

Section 6. Accidental release measures

Environmental precautions

Personal precautions, protective equipment and emergency procedures

No action shall be taken involving any personal risk or without suitable training. Keep

unnecessary and unprotected personnel from entering. Do not touch or walk through

spilled material. Avoid breathing vapor or mist. Provide adequate ventilation. Wear

appropriate respirator when ventilation is inadequate. Put on appropriate personal

protective equipment.

Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains

and sewers. Inform the relevant authorities if the product has caused environmental

pollution (sewers, waterways, soil or air). Water polluting material. May be harmful to

the environment if released in large quantities.

Methods and materials for containment and cleaning up

For non-emergency

personnel

For emergency responders

If specialized clothing is required to deal with the spillage, take note of any information in

Section 8 on suitable and unsuitable materials. See also the information in "For non-

emergency personnel".

Small spill

Stop leak if without risk. Move containers from spill area. Approach release from

upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash

spillages into an effluent treatment plant or proceed as follows. Contain and collect

spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or

diatomaceous earth and place in container for disposal according to local regulations

(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated

absorbent material may pose the same hazard as the spilled product. Note: see

Section 1 for emergency contact information and Section 13 for waste disposal.

Large spill

Stop leak if without risk. Move containers from spill area. Dilute with water and mop up

if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and

place in an appropriate waste disposal container. Dispose of via a licensed waste

disposal contractor.

Section 7. Handling and storage

Advice on general

occupational hygiene

Conditions for safe storage,

including any

incompatibilities

Eating, drinking and smoking should be prohibited in areas where this material is

handled, stored and processed. Workers should wash hands and face before eating,

drinking and smoking. See also Section 8 for additional information on hygiene

measures.

Store in accordance with local regulations. Store in original container protected from

direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials

(see Section 10) and food and drink. Store locked up. Keep container tightly closed

and sealed until ready for use. Containers that have been opened must be carefully

resealed and kept upright to prevent leakage. Do not store in unlabeled containers.

Use appropriate containment to avoid environmental contamination.

Protective measures

Put on appropriate personal protective equipment (see Section 8). Avoid exposure -

obtain special instructions before use. Do not handle until all safety precautions have

been read and understood. Do not get in eyes or on skin or clothing. Do not ingest.

Avoid breathing vapor or mist. Avoid release to the environment. If during normal use

the material presents a respiratory hazard, use only with adequate ventilation or wear

appropriate respirator. Keep in the original container or an approved alternative made

from a compatible material, kept tightly closed when not in use. Empty containers retain

product residue and can be hazardous. Do not reuse container.

Precautions for safe handling

4/12

Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)