Specification Sheet

ManualsBrandsGeneral Finishes ManualsHome Decor1 Gallon Interior Dye Stain Water Base Wood Stain

The industry leader in water based technology.

NOTICE: All of the above statements, recommendations, suggestions, and data concerning the subject material are based on laboratory results and

believed to be reliable. We expressly do not represent, warrant, or guarantee the accuracy, completeness or reliability of same, or the material or

the results to be obtained from the use thereof, neither do we warrant that any such use, either alone or in combination with other materials shall be

free of the rightful claim of any third party by way of INFRINGEMENT or the like and (THE MANUFACTURER DISCLAIMS ALL

WARRANTIES, EXPRESSED OR IMPLIED,) OF MERCHANTABILITY and FITNESS FOR A PARTICLUAR PURPOSE.

Mixing and Application:

Catalyst Ratio: None

Pot Life: Not Applicable

Shelf Life: 6 months, minimum

Reducer/Thinner: EF Extender (6 –12%)

Sealer & Finish Recommendation:

Can be topcoated with most water base, oil base, and sol-

vent base finishes, varnishes, & lacquers. Compatible

with all General Finishes topcoats. Test adhesion and

compatibility on all other systems. Color will vary depend-

ant upon wood and dwell time before wiping

General Finishes Sanding Sealer is recommended if not

using a self sealing finish for optimum build and smooth-

ness. Use: Water Base: PolyAcrylic, High Performance,

Enduro Water Base Lacquer, Enduro Poly, Pre-Cat Ure-

thane, or EnduroVar. Note: If Pre-Cat Sanding Sealer

must be used under Pre-Cat Urethane. Oil Base: General

Finishes Arm-R-Seal. Solvent Base: Most pre-catalyzed

lacquers and conversion varnishes.

Surface Preparation:

Surface must be clean, dry and free of dust, dirt, grease,

wax, or contaminants. For Raw wood, sand with #150

(preferred) to #220 grit. Fill all nail holes or cracks using a

water base filler or putty. Remove all dust by vacuuming or

wiping with a damp cloth. Do not use tack cloths which

contain linseed oils.

Application:

 Conventional Spray:

 Air Assisted Airless

 HVLP

 Dip

 Brush

Cautions:

 Mix container before use

 Protect from freezing

 Consult MSDS

 Clean-up Information:

For best results, clean all equipment

with General Finishes Brush and Gun

Cleaner. General clean-up with soap

and water recommended. Rinse

thoroughly with clean water.

Enduro Dye Stain-081910