User's Manual

154
X-C 6250 Pro Users Manual
79-0003-003 22 October 1999
Miscellaneous
All of the indicator lights are flashing
• This can occur during a Power On Self Test (POST) and means the
test has failed. Reset the mobile computer by pressing
CTRL+ALT+DEL or holding down both mouse buttons for at least 10
seconds and then releasing the buttons.
I receive an out of memory error message
• Too many applications may be running at the same time. Close
applications you dont need.
• Run MS-DOS applications in full screen rather than a window. Press
ALT+ENTER to toggle between full screen and window mode.
• If youre using desktop wallpaper, set wallpaper to None. To do this,
choose Display from Control Panel and make the appropriate change.
• Make sure you have enough space on your hard disk. Contact your
supervisor or your organizations help desk for assistance.
• Set up a permanent swap file. Contact your supervisor or your
organizations help desk for assistance.
Holding down both mouse buttons to reset the computer doesnt
always work
• Try resetting the computer again. If this doesnt work, remove all
power, and allow the unit to remain idle for ten minutes. After ten
minutes, connect external power and retry.
This warning message appears when I restart the computer:
Warning Include specifies memory already excluded at D100"
• This problem is generally caused when the PC card controller is out
to lunch. Reset the computer once again by holding down both
mouse buttons for at least 10 seconds and then releasing the
buttons.
CAUTION Restarting your computer may corrupt files or data.