User's Manual

132
X-C 6250 Pro Users Manual
79-0003-003 22 October 1999
MS-DOS Messages
The MS-DOS operating system may display a warning or error message
if it encounters a problem with a command in the CONFIG.SYS or
AUTOEXEC.BAT file, or a command that you entered at the DOS
prompt. Following are a few of the most common MS-DOS messages.
Bad command or file name
A command was entered that is spelled incorrectly or does not exist on
the computer.
Invalid media type reading drive D
Abort, Retry, Fail?
The PC memory card may not be formatted. Press A to abort, then
format the card using the MS-DOS Format command, or from Windows
using the Format Disk command.
Invalid drive specification
You tried to access a drive that does not exist. This can happen if you
try to access drive D, but the PC card drivers are not loaded. Report
this error to your supervisor or help desk.
Non-System disk or disk error
Replace and press any key when ready
This can occur if a PC memory card is in the card socket and you
restart the computer. Remove the card, and then press any key.
Not ready reading drive D
Abort, Retry, Fail?
Make sure that the PC card is inserted fully into the card socket, then
press R to retry. See Section 8, Using PC cards for more information.