User's Manual

130
X-C 6250 Pro Users Manual
79-0003-003 22 October 1999
WARNING! Boot sector 0 has changed
The boot sector of the hard drive has been modified. This message also
may be displayed when booting from drive C after booting from another
device. Pressing
F1 will allow the system to continue to boot. If this
problem persists, contact your organizations help desk.
-WARNING: CMOS checksum invalid - run SCU
-WARNING: CMOS failure - run SCU
Run the System Configuration Utility (SCU) to set the system
configuration. If the problem persists, contact your organizations help
desk. (See Section 5, Customizing Settings, for more information
about the SCU.)
-WARNING: Floppy controller failed
-WARNING: Floppy disk track 0 failed
Restart the computer by pressing both mouse buttons for at least ten
seconds and then releasing the buttons. If the problem persists, contact
your organizations help desk.
WARNING: Floppy information invalid - run SCU
Run the System Configuration Utility (SCU) to set the system
configuration. If the problem persists, contact your organizations help
desk. (See Section 5, Customizing Settings, for more information
about the SCU.)
-WARNING: Keyboard controller failure
-WARNING: Keyboard failure
Reboot the computer by pressing CTRL+ALT+DEL. If the problem
persists, the keyboard is not usable; contact your organizations help
desk.
-WARNING: No bootable floppy drive 0 installed
-WARNING: No interrupts from timer 0
Restart the computer by pressing both mouse buttons for at least ten
seconds and then releasing the buttons. If the problem persists, contact
your organizations help desk.