User's Manual

Table Of Contents
127
Appendix A. Error Messages
79-0003-003 22 October 1999
-Disk not found
-FATAL: CMOS RAM test failed
-FATAL: DMA controller faulty
-FATAL: Faulty DMA page registers
-FATAL: Faulty refresh circuit
-FATAL: Interrupt controller failed
-FATAL: No RAM found
-FATAL: No video display found
-FATAL: RAM error at location xxxxxx: Wrote: xx Read: xx
-FATAL: ROM checksum incorrect
Restart the computer by pressing both mouse buttons for at least ten
seconds and then releasing the buttons. If the problem persists, contact
your supervisor or your organizations help desk.
Fixed disk controller failure
Disk controller is not responding. Report this error to your supervisor or
your organizations help desk.
Fixed disk failure
Report this error to your supervisor or your organizations help desk.
Floppy disk fault - insert valid boot disk and press any key
If no floppy drive is present, run the System Configuration Utility (SCU)
and disable the floppy disk controller. (See Section 5, Customizing
Settings, for more information about the SCU.)
Gate A20 failure
Hardware failure. Report this error to your supervisor or your
organizations help desk.