User's Guide

Getting Started
2110059 Rev 1.1 Proprietary and Confidential Page 9
5. Attach the modem to the connector strap using the same procedure as the MIB end of the
connector.
CAUTION
Although the MIB provides support for the full SB Series of modems, it is not intended
to support more than one modem at a time. Attaching more than one modem can
damage circuitry.
6. Place the antenna is a suitable location, attach the antenna connector adapter to the antenna
cable, and attach the cable to the modem.
7. Ensure the modem power switch is OFF.
8. Plug the 12V DC power adapter into a 120V AC outlet and connect the power supply to the
MIB.
9. Switch on the MIB and modem power using the POWER switch on the MIB.
The remaining LED indicators should come on. Power indicators for 7V and 5V should show
red. The Serial Breakout Box indicators should all light; the DSR signal shows green. The
Status indicators should begin operation to specification as the modem initializes. In about 6
to 10 seconds (following the modem’s internal initialization) the CTS serial signal should go
green and OK should appear on the PC terminal.
10. Type AT<enter> at the host terminal. The modem should reply with OK.
The modem is now ready to be used with the host computer.
You may now continue to use the modem with the terminal application, or you may close the
terminal application and use Watcher and WirelessExpert (described below) to configure and use
the modem.