User's Manual

Turn the computer upside down and lay it on a flat surface.

2. Carefully remove the two RAM compartment cover screws and remove the RAM compartment

cover.

3. Gently pull tabbed latched in the direction of the arrows (1). The card will pop up slightly.

4. Pull upwards on the card and then slide the card out (2).

Inserting a Memory Card

1. Hold the memory card by its edges with the edge-connector side towards the slot.

2. Hold the card at a shallow angle (about 25 degrees) and insert the edge connector into the

connector slot. The "gold teeth" of the edge connector should no longer be visible when the card is

fully inserted.

3. Press the card downwards so that it is flat inside the compartment. You may hear an audible click

as the latches of the connector lock the card in place.

4. Replace the RAM compartment cover and secure it with the two screws.

Your notebook computer will automatically detect the change in RAM capacity when it restarts. You

can verify RAM capacity has changed in the Setup Utility or in Windows:

1. Setup: Press DEL during boot-up when you see the "Hit DEL if you want to run Setup" prompt.

Then select Standard CMOS Setup. This screen shows the base memory and the extended memory.

2. Windows: Right click on my computer and select properties. The bottom of the system Properties

General tab lists the memory detected by Windows.

Audio

Your com

uter includes 16-

it hi

h-fidelit

stereo audio. The s

eaker is located above the dis

72_0128_001

16 May 2005

oration. All ri

hts reserved.

GoBook

PRO II Help

e 26 of 100GoBook PRO II Hel

5/16/2005file://C:\Documents%20and%20Settin

s\barvill

.ITRXNT1\Local%20Settin

s\Tem

\~hh7...