User's Manual

Display

The display performance is slow

{

The temperature may be too cold. Move the computer to a warmer operating environment.

I can’t read the display

{

Adjust the brightness level using FN+F6 and FN+F7 .

{

The automatic power-saving mode may have shut off (suspended) the computer. Press any

key to resume.

{

If the display brightness is unreadable after a resume or reboot but is easily adjusted with

FN+F6 and FN +F7 you may have set Stealth mode in the Setup Utility. If you disable

Stealth mode the display and backlight will operate normally.

The underlined, inverse, and hypertext characters are difficult to read on the screen

{

Change the color scheme. From the Start Menu select Settings, Control Panel, choose

Display, and then tap the Appearance tab to make changes to the color scheme.

I can’t see the cursor while using the DOS editor

{

Press FN+INSERT

to change from insert mode to overwrite mode to enable a block cursor.

When it defaults to insert mode, the DOS editor uses an underline cursor which is less

visible than the block cursor for overwrite mode.

The display appears to have random pixels darkened after scrolling

{

Contact your supervisor or your organization’s help desk for information about correcting

this problem.

I changed my display resolution, but I see no difference on the screen

{

Try restarting your computer for the changes to take effect.

72_0103_003

10 December 2002

GoBook II™ Help

e 64 of 71GoBook II Hel

2/17/2004file://C:\Documents%20and%20Settin

s\harwoodm.ITRXNT1\Local%20Settin

s\Tem

\~...