User's Manual

72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Auto-Detect Hard Disks
When the Auto-Detect Hard Disks option is selected, the BIOS will automatically detect Primary Master
and Secondary Slave settings.
NOTE If you Auto-Detect your Hard Disk Drive while your media bay drive is empty, you will need to
reset the Secondary Master to Auto On before you can use the CD-ROM (or other media devices).
72_0103_003
10 December 2002
©
2002 Itronix Corporation. All rights reserved.
Change Password
Change Supervisor Password
A supervisor password must be set before a lower-level password can be set. After selecting Change
Supervisor Password, press Enter. You will be prompted for the new password, and then again to
verify it. Type in six or fewer keystrokes. If you make an error, press Esc to start over.
Change User Password
With a User password, you can enter the Setup Utility and change or remove the User password, but you
cannot enter the Setup Utility and change or remove the Supervisor password. You also cannot enable
diskette access if it has been disabled.
GoBook II™ Help
GoBook II™ Help
Pa
g
e 43 of 71GoBook II Hel
p
2/17/2004file://C:\Documents%20and%20Settin
g
s\harwoodm.ITRXNT1\Local%20Settin
g
s\Tem
p
\~...