User's Manual

72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Auto-Detect Hard Disks
When the Auto-Detect Hard Disks option is selected, the BIOS will automatically detect Primary Master and
Secondary Slave settings.
NOTE
If you Auto-Detect your Hard Disk Drive while your media bay drive is empty, you will need to reset the
Secondary Master to
Auto On
before you can use the CD-ROM (or other media devices).
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.


Change Password
Change Supervisor Password
A supervisor password must be set before a lower-level password can be set. After selecting Change Supervisor
Password, press
Enter
. You will be prompted for the new password, and then again to verify it. Type in six or fewer
keystrokes. If you make an error, press
Esc
to start over.
Change User Password
With a User password, you can enter the Setup Utility and change or remove the User password, but you cannot enter
GoBook II™ Help

GoBook II™ Help

Page
45
of
74
GoBook II Help
9/30/2003
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh49BC.htm