User Manual

using it.

As your battery ages, the maximum capacity that it can hold naturally decreases, and even the best
maintained batteries eventually need to be retired. Consider replacing the battery if you are not
getting the usage you need from it.
72_0103_003
10 December 2002
©
2002 Itronix Corporation. All rights reserved.
Display
The display performance is slow

The temperature may be too cold. Move the computer to a warmer operating environment.
I can’t read the display

Adjust the brightness level using
FN
+
F6
and
FN
+
F7
.

The automatic power-saving mode may have shut off (suspended) the computer. Press any key to
resume.

If the display brightness is unreadable after a resume or reboot but is easily adjusted with
FN
+
F6
and
FN
+
F7
you may have set Stealth mode in the Setup Utility. If you disable Stealth mode
the
display and backlight will operate normally.
The underlined, inverse, and hypertext characters are difficult to read on the screen

Change the color scheme. From the Start Menu select Settings, Control Panel, choose Display,
and then tap the Appearance tab to make changes to the color scheme.
I can’t see the cursor while using the DOS editor

Press
FN
+
INSERT
to change from insert mode to overwrite mode to enable a block cursor.
When it defaults to insert mode, the DOS editor uses an underline cursor which is less visible than
the block cursor for overwrite mode.
The dis
p
la
y
a
pp
ears to have random
p
ixels darkened after scrollin
g
GoBook II™ Help
Pa
g
e67of75GoBook II Hel
p
12/12/2002file://C:\Documents%20and%20Settin
g
s\harwoodm\Local%20Settin
g
s\Tem
p
\~hhA88F.h...