User Manual

72_0103_003

10 December 2002

Hard Drive Care and Handling

There is one hard drive option for the GoBook II: a removable shock-mounted 2.5-inch hard drive. All

hard drives contain media for data storage in the form of a rotating disk, read/write head(s), a motor, and

electronics for interfacing and control. Drives can be susceptible to damage from severe shock and other

stressful environmental impacts. The degree of susceptibility to damage is directly related to the

individual hard drive and the mounting system employed.

When reading or writing to the hard disk

, the head is “flying” on a thin layer of air, micro-inches above

the disk. A shock can cause the read/write head to contact the spinning disk, resulting in immediate loss

of stored data and possible physical damage to the disk. It could also create loose debris in the drive

enclosure that may cause progressive damage over time.

To reduce exposure to high operating shocks, the GoBook II uses power modes for the hard drive that

prevent the read/write heads from being positioned over the disk when it is not being used: idle mode

and standby mode.

You can reduce the risk of damage to the hard drive and increase the reliability of the hard drive and

data integrity by following the recommendations below.

Installing and Removing the Hard Drive

To remove the hard drive:

1. Shut down the unit and remove external power.

2. Open the battery door and remove the battery using the extraction tape. The hard drive is in a

cassette that can be seen in the batter

well

ust under the RTC hatch.

GoBook II™ Help

e57of75GoBook II Hel

12/12/2002file://C:\Documents%20and%20Settin

s\harwoodm\Local%20Settin

s\Tem

\~hhA88F.h...