User's Manual

A supervisor password must be set before a lower-level password can be set. After selecting Change
Supervisor Password, press
Enter
. You will be prompted for the new password, and then again to
verify it. Type in six or fewer keystrokes. If you make an error, press
Esc
to start over.
Change User Password
With a User password, you can enter the Setup Utility and change or remove the User password, but you
cannot enter the Setup Utility and change or remove the Supervisor password. You also cannot enable
diskette access if it has been disabled.
72_0103_003
10 December 2002
©
2002 Itronix Corporation. All rights reserved.
Auto Configuration with Optimal Settings
The Auto Configuration menu resets the computer to default values. The Auto Detect Hard Disks
likewise helps users to configure their systems quickly. When you see the prompt, "Load high
performance settings
(y/n)
" choose y to reset the computer to default values.
72_0103_003
10 December 2002
©
2002 Itronix Corporation. All rights reserved.
Exit and Saving
Save Settings and Exit
Select this o
p
tiontosavechan
g
es to the field values and restart the com
p
uter usin
g
the new values.
GoBook II™ Help
GoBook II™ Help
Pa
g
e47of76GoBook II Hel
p
1/31/2003file://C:\Documents%20and%20Settin
g
s\harwoodm\Local%20Settin
g
s\Tem
p
\~hh35F9.htm