User's Manual

You can reduce the risk of damage to the hard drive and increase the reliability of the hard drive and
data integrity by following the recommendations below.
Installing and Removing the Hard Drive
To remove the hard drive:
1. Shut down the unit and remove external power.
2. Open the battery door and remove the battery using the extraction tape. The hard drive is in a
cassette that can be seen in the battery well just under the RTC hatch.
3. On the left side of the hard drive cassette you will see a small black release lever. Pull the lever
towards you (away from the direction of the RTC hatch) and slide the cassette out into the battery
storage area.
4. Lift the hard drive cassette from the battery storage area.
To install the hard drive:
1. Make sure the unit is shut down and external power is removed.
2. The battery door should be off the unit and the battery removed.
3. Make sure the small black release lever is rotated towards
y
ou (in its released
p
osition).
Pa
g
e59of76GoBook II Hel
p
4/28/2003file://C:\Documents%20and%20Settin
g
s\harwoodm.ITRXNT1\Local%20Settin
g
s\Tem
p
\~...