User's Manual Part 1

¡
Check to make sure the COM ports are off. For example, exit any application that uses COM ports.
¡
Make sure external power is not connected. Depending on power settings, some systems will not suspend automatically when
they are connected to external power.
¡
Make sure the standby time is set properly in the Power Management program.
The system date and time are incorrect
¡
Reset the correct date and time by choosing the Date/Time icon from Control Panel and making the appropriate changes.
I receive an out of memory error message
¡
Too many applications may be running at the same time. Close applications you dont need.
¡
Run MS-DOS applications in full screen rather than a window. Press ALT+ENTER to toggle between full screen and window
mode.
¡
If youre using desktop wallpaper, set wallpaper to None. To do this, choose Display from Control Panel and make the
appropriate change.
¡
Make sure you have enough space on your hard disk . Contact your supervisor or your organizations help desk for assistance.
¡
Set up a permanent swap file. Contact your supervisor or your organizations help desk for assistance.
Holding down the Power button to reset the computer doesnt always work
¡
Try resetting the computer again. If this doesnt work, remove all power, including the battery pack, and allow the unit to remain
idle for ten minutes. After ten minutes, connect external power and retry.
The LED's, backlight, and/or keyboard backlight don't illuminate.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable Stealth mode.
The computer doesn't make any sounds, even during boot-up.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable Stealth mode.
The fan stopped running.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable Stealth mode.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Mouse
I have difficulty double-clicking the mouse fast enough
¡
From the Start Menu, select Settings, Control Panel, and then choose Mouse. The Buttons tab contains the setting for the double-
click speed.
I cant see the mouse pointer
¡
The mouse pointer may be off the screen. Move the mouse until it reappears on the screen.
¡
From the Start Menu, select Settings, Control Panel, and then choose Mouse. The Motion tab contains settings for the mouse
speed and mouse trails.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
GoBook II Help
GoBook II Help
Page
40
41
GoBook II Help
6/22/2004
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh4848.htm