User's Manual Part 1

Fixed disk failure
Report this error to your supervisor or your organization's help desk.
GA20 Error
Hardware failure. Report this error to your supervisor or your organization's help desk.
Hard disk boot sector invalid
Hard disk failed
Restart the computer by pressing the power button for at least eight seconds. If the problem persists, contact your supervisor or your
organization's help desk.
Insert boot-disk and press any key
Restart the computer by pressing the Power Button for at least eight seconds. If the problem persists, contact your supervisor or your
organization's help desk.
KB / Interface Error
Reboot the computer by pressing CTRL+ALT+DEL. If the message persists, and the keyboard is not usable, report this error to your
supervisor or your organization's help desk.
Keyboard Error
Unlock Keyboard
Restart the computer by pressing the Power Button for at least eight seconds. If the problem persists, contact your supervisor or your
organization's help desk.
No boot device available
Reboot the computer by pressing CTRL+ALT+DEL. If the message persists, the hard disk may need to be replaced. Report this error
to your supervisor or your organization's help desk.
No boot sector on hard disk
Data corrupted on hard disk. Restore hard disk data by rebooting from CD-ROM.
Non-system disk or disk error - Replace and press any key to continue
Remove the non-bootable PC memory card or floppy disk and press any key to reboot.
Non-system disk - insert boot disk and press any key
Restart the computer by pressing the Power Button for at least eight seconds. If the problem persists, contact your supervisor or your
organization's help desk.
Press the F1 key to resume
This message indicates that an error was found during POST. Pressing the F1 key allows the system to attempt to boot.
CPU Fan Error
Report the error to your supervisor or your organization's help desk.
Battery too low to warm the hard drive. Shutting down...
There is not enough battery power to operate the Hard Disk Drive (HDD) heater and the temperature is too cold to safely turn on the
HDD. Apply external power and/or move the unit to a location that is at least 5°C.
Warming internal hard drive. Please wait...
The temperature is less than 5°C and the HDD heater is operating. The unit will continue booting when the HDD temperature is warm
enough for safe operation.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
MS-DOS Messages
GoBook II Help
Page
34
41
GoBook II Help
6/22/2004
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh4848.htm