User's Manual Part 1

The keyboard backlight does the following whether stealth mode is enabled or disabled:

Does not illuminate when the system is off or suspended

Does not illuminate on resume or boot

Turns off when FN+F1 is pressed to turn off the display.

72_0103_003

10 December 2002

Auto-Detect Hard Disks

When the Auto-Detect Hard Disks option is selected, the BIOS will automatically detect Primary Master and Secondary Slave settings.

NOTE If you Auto-Detect your Hard Disk Drive while your media bay drive is empty, you will need to reset the Secondary Master to Auto

On before you can use the CD-ROM (or other media devices).

72_0103_003

10 December 2002

Change Password

Change Supervisor Password

A supervisor password must be set before a lower-level password can be set. After selecting Change Supervisor Password, press Enter. You

will be prompted for the new password, and then again to verify it. Type in six or fewer keystrokes. If you make an error, press Esc to start

over.

Change User Password

With a User password, you can enter the Setup Utility and change or remove the User password, but you cannot enter the Setup Utility and

change or remove the Supervisor password. You also cannot enable diskette access if it has been disabled.

72_0103_003

10 December 2002

Auto Configuration with Optimal Settings

The Auto Configuration menu resets the computer to default values. The Auto Detect Hard Disks likewise helps users to configure their

systems quickly. When you see the prompt, "Load high performance settings (y/n)" choose y to reset the computer to default values.

GoBook II™ Help

Page

GoBook II Help

6/22/2004

file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh4848.htm