User's Manual Part 1

This section of the Setup Utility manages power settings. To save power, you may select the time the computer may idle before going into
standby, or a low power state, then into suspend mode. See Power Management for an introduction to suspend modes.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Peripheral Setup
Settings on this page allow you to change port configurations.
Field Setting Function
Intel ® SpeedStep
Technology
Recommended Enables the system to reduce the CPU speed when the battery is in use to conserve
power. This is the default setting.
Battery The computer will utilize Intel ® SpeedStep Technology when the battery is in use. This
technology lowers the CPU clock speed to save power.
Performance The computer always uses optimal CPU clock speed and does not utilize Intel ®
SpeedStep Technology
Reverse When the battery is in use, the computer will utilize Intel ® SpeedStep Technology.
When the computer is running on AC power it will run in Performance mode.
Disabled Disables Intel ® SpeedStep Technology feature.
Battery Low
Warning Beep
Disabled
Battery low warning beep disabled.
Enabled Battery low warning beep enabled (beeps at 7% remaining).
Radio Wake-Up Enabled The internal radio is allowed to resume the unit.
Disabled The internal radio is not allowed to resume the unit.
GoBook II™ Help
Field Setting Function
Internal
MDC
Modem
Auto
Disabled
Default is disabled.
Onboard
Serial
Port A &
B
Auto COM 1 is assigned to the serial port
located at the rear of your GoBook
II. Set this field to Auto to enable
the system to automatically assign an
I/O address and interrupt to the port.
Disabled Disables COM 1. You may need to
remove this port in Windows to
release the IRQ resource for use by
Page
23
of
41
GoBook II Help
6/22/2004
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh4848.htm