User's Manual Part 1

CAUTION Before attempting to configure a hard disk drive, make sure you have the configuration information supplied by the
manufacturer of your hard drive. Incorrect settings can result in your system not recognizing the installed hard disk.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Advanced CMOS Setup
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Power Management Setup
Blk Mode Multi-sector transfers enabled
PIO
Mode
PIO (Programmed Input/Output) mode refers to data transfer method used by IDE drives. These modes use the CPU's
registers for data transfer in contrast with DMA (Direct Memory Access), which transfers directly between main
memory and the peripheral device. The default value Auto lets the system automatically read setup information it
needs for setup from the hard disk drive. Five explicit values, 0 to 4, are also possible.
32Bit
Mode
Enables hard drive 32-bit data transfer. Only some hard disk controllers support 32Bit mode.
GoBook II
™
Help
Field Setting Function
Bootup
Sequence
C; A;
CDROM
Use this field to set the devices from which the system should boot in order of priority. The default value
is C; A; CDROM,. This means the computer will attempt to boot from the hard disk drive (HDD), then
the floppy disk drive (FDD), then the CD-ROM.
A; C;
CDROM
the computer will boot from the FDD, then the HDD, then the CD-ROM. The BIOS will auto detect a
floppy disk in boot device A:
CDROM;
A; C;
The computer will boot from the CD-ROM, then the FDD, then the HDD.
S.M.A.R.T. for
Hard
Disabled
Enabled
The S.M.A.R.T. (Self-Monitoring, Analysis, and Disks Reporting Technology) system is a diagnostics
technology that monitors and predicts device performance. The disk drive software monitors the internal
performance of the motors, media, heads, and electronics of the drive. Only S.M.A.R.T. Hard Disks are
supported. The default is Enabled.
Bootup Num-
Lock
Off
On
Use this field to initially disable the Num-Lock feature of the internal keyboard when the GoBook II
starts The default is Off.
Display
Expansion
Mode
Enabled
Disabled
If you are using DOS or a 640 x 480 resolution to run windows, the display will not fill the entire screen.
Enable this mode to expand the display to the entire screen.
Password
Check
Setup The default value is Setup, which specifies that a password is only required to enter the Setup Utility.
Always If Always is selected, the password is required when the system is booted up or resuming from a
suspend-to-disk.
GoBook II
™
Help
Page
22
of
41
GoBook II Help
6/22/2004
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh4848.htm