User Manual
{
As your battery ages, the maximum capacity that it can hold naturally decreases, and even
the best maintained batteries eventually need to be retired. Consider replacing the battery if
you are not getting the usage you need from it.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Display
The display performance is slow
{
The temperature may be too cold. Move the computer to a warmer operating environment.
I can’t read the display
{
Adjust the brightness level using
FN
+
F6
and
FN
+
F7
.
{
The automatic power-saving mode may have shut off (suspended) the computer. Press any
key to resume.
{
If the display brightness is unreadable after a resume or reboot but is easily adjusted with
FN
+
F6
and
FN
+
F7
you may have set Stealth mode in the Setup Utility. If you disable
Stealth mode the display and backlight will operate normally.
The underlined, inverse, and hypertext characters are difficult to read on the screen
{
Change the color scheme. From the Start Menu select Settings, Control Panel, choose
Display, and then tap the Appearance tab to make changes to the color scheme.
I can’t see the cursor while using the DOS editor
{
Press
FN
+
INSERT
to change from insert mode to overwrite mode to enable a block cursor.
When it defaults to insert mode, the DOS editor uses an underline cursor which is less
visible than the block cursor for overwrite mode.
The display appears to have random pixels darkened after scrolling
{
Contact your supervisor or your organization’s help desk for information about correcting
this problem.
I changed my display resolution, but I see no difference on the screen
{
Tr
y
restartin
g
y
our com
p
uter for the chan
g
es to take effect.
GoBook II™ Help
Pa
g
e 61 of 68GoBook II Hel
p
8/16/2004file://C:\Documents%20and%20Settin
g
s\harwoodm.ITRXNT1\Local%20Settin
g
s\Tem
p
\
~
...