User's Manual

47
Section 4. If You Have a Wireless Modem
77-0100-001 12 September 2000
1 Click OK.
2 Click Yes to confirm.
3 Click Yes to restart your computer.
• If necessary, activate the Nokia Monitor program running on the task bar and verify that you have at least one
bar of signal strength in the upper left hand corner of the Monitor window.
• Read and correct any error messages displayed in window (such as “Insert SIM card”).
• Run the serial GSM radio application of your choice
RIM 802D (datatac) for Motient
• With the exception of the built-in diagnostic program of the RIM radio, there are no standard applications
shipped that allow the RIM 802D radio to be used for communication.
The RIM 802D radio understands two protocols Native Control Language (NCL) and RIM access protocol (RAP).
To use the RIM 802D radio, an application that uses one of these protocols must be installed on the computer and
configured to communicate on COM4.
RIM 902M (Mobitex) for Cingular
• With the exception of the built-in diagnostic program of the RIM radio, there are no standard applications
shipped that allow the RIM 902M radio to be used for communication.
The RIM 902M radio understands two protocols MASC and RIM access protocol (RAP). To use the RIM 902M
radio, an application that uses one of these protocols must be installed on the computer and configured to communi-
cate on COM4.
Lucent Wireless LAN
• Go to your preferred LAN applications and run normally.