User's Manual
Table Of Contents
- Contents
- Section 1 Getting Started
- Introduction
- Unpacking Your System
- Precautions
- Checklists
- Features
- The First Time. . .
- Connecting the AC Adapter
- Installing the Battery
- Turning the Computer On and Off
- Adjusting the Volume
- Calibrating the Touch Screen
- Startup Problems?
- Section 2 Getting Familiar with Your Computer
- Introduction
- Individual Parts
- LED Activity Indicators
- LED Power / Radio Indicators
- Keyboard Basics
- Restarting the Computer
- Primary Keys
- Arrow Keys
- Function Keys
- Numeric Keypad
- Touchpad
- General Guidelines
- Scrolling Buttons
- Connecting an External Keyboard or Mouse
- Disk Drives
- The PC Card Slot
- Connecting to an External Monitor
- Section 3 Making Connections
- Making Connections
- Rear Connectors
- Left Side Connectors
- Right Side Connectors
- Section 4 If You Have a Wireless Modem
- Introduction
- Before You Start: Register!
- Registering Your Wireless Modem
- Wireless Modem LED Status
- Installing Your Wireless Modem Software
- Using Your Wireless Modem
- Section 5 Power Management
- Power Management
- Battery Calibration
- Monitoring Battery Power
- Low Battery Alarms
- Battery Charging
- Power Saving Modes
- Suspend Mode
- Initiating Suspend Mode
- Power Button Settings
- When to Replace the Battery
- Heat Considerations
- Section 6 Customizing Your Bios Settings
- Using the BIOS Setup Utility
- BIOS Setup Menu
- Starting the BIOS Setup Utility
- The Main Menu
- Navigating and Entering Information in BIOS
- Standard CMOS Setup
- Standard Feature Description
- Advanced CMOS Setup
- Power Management
- Peripheral Setup
- Auto-Detect Hard Disk
- Change Supervisor Password
- Change User Password
- Auto Configuration with Optimal Settings
- Exiting and Saving
- Section 7 Optional Equipment and Accessories
- Vehicle Adapter
- Vehicle Cradle
- PRECAUTIONS
- Charging Batteries
- Communicating with Other Devices
- Surge Protection
- Selecting the Right Surge Protection
- Selecting the Right Equipment
- Section 8 Maintenance and Storage
- Introduction
- Touch Screen Care
- Hard Drive Care and Handling
- Internal Hard Drives
- External PC Card Hard Drives
- Battery Maintenance and Storage
- Maintaining Batteries
- Storing Batteries
- Computer Maintenance and Storage
- Maintaining Your Computer
- Storing Your Computer
- Appendix A Error Messages
- Introduction
- POST Messages
- MS-DOS Messages
- Windows Messages
- Application Messages
- Appendix B Troubleshooting
- What to Try First
- For More Help
- Common Solutions to Common Problems
- Applications
- Batteries
- Cellular Modem
- Display
- Hard Disk
- I/O Ports
- Keyboard
- Landline Modems
- Miscellaneous
- Mouse
- PC Cards
- Pen/Touch Screen
- Wireless Modems
- Appendix C Glossary
- Index
7
77-0100-001 12 September 2000
Section 1. Getting Started
3 Connect the AC adapter power cord to an AC outlet.
4 Lift the display to open the LCD.
5 Open the LCD panel to a comfortable viewing angle.
6 Press the power button to turn on the power.
Note When the battery is installed, see Installing the Battery below, it starts
charging automatically. At moderate temperatures, approximately 70°
Fahrenheit (21°C), the battery will be fully charged in four to six hours. In
warmer or cooler temperatures, the battery can take much longer to fully
charge. Refer to Section 5 Power Management for additional information.
Installing the Battery
Make sure the computer is sheltered when you install the Lithium Ion battery; the computer is not weather sealed
until the battery door is properly installed. The battery should be fully charged before you operate the unit on battery
power. To get the most from your battery, follow the guidelines in Section 5 Power Management.
To install the battery
1 Remove the battery door.
2 Align the battery connectors and place the battery in the computer.
3 Replace the battery door and rotate the door latches to secure the door.