User's Manual
Table Of Contents
- Contents
- Section 1 Getting Started
- Introduction
- Unpacking Your System
- Precautions
- Checklists
- Features
- The First Time. . .
- Connecting the AC Adapter
- Installing the Battery
- Turning the Computer On and Off
- Adjusting the Volume
- Calibrating the Touch Screen
- Startup Problems?
- Section 2 Getting Familiar with Your Computer
- Introduction
- Individual Parts
- LED Activity Indicators
- LED Power / Radio Indicators
- Keyboard Basics
- Restarting the Computer
- Primary Keys
- Arrow Keys
- Function Keys
- Numeric Keypad
- Touchpad
- General Guidelines
- Scrolling Buttons
- Connecting an External Keyboard or Mouse
- Disk Drives
- The PC Card Slot
- Connecting to an External Monitor
- Section 3 Making Connections
- Making Connections
- Rear Connectors
- Left Side Connectors
- Right Side Connectors
- Section 4 If You Have a Wireless Modem
- Introduction
- Before You Start: Register!
- Registering Your Wireless Modem
- Wireless Modem LED Status
- Installing Your Wireless Modem Software
- Using Your Wireless Modem
- Section 5 Power Management
- Power Management
- Battery Calibration
- Monitoring Battery Power
- Low Battery Alarms
- Battery Charging
- Power Saving Modes
- Suspend Mode
- Initiating Suspend Mode
- Power Button Settings
- When to Replace the Battery
- Heat Considerations
- Section 6 Customizing Your Bios Settings
- Using the BIOS Setup Utility
- BIOS Setup Menu
- Starting the BIOS Setup Utility
- The Main Menu
- Navigating and Entering Information in BIOS
- Standard CMOS Setup
- Standard Feature Description
- Advanced CMOS Setup
- Power Management
- Peripheral Setup
- Auto-Detect Hard Disk
- Change Supervisor Password
- Change User Password
- Auto Configuration with Optimal Settings
- Exiting and Saving
- Section 7 Optional Equipment and Accessories
- Vehicle Adapter
- Vehicle Cradle
- PRECAUTIONS
- Charging Batteries
- Communicating with Other Devices
- Surge Protection
- Selecting the Right Surge Protection
- Selecting the Right Equipment
- Section 8 Maintenance and Storage
- Introduction
- Touch Screen Care
- Hard Drive Care and Handling
- Internal Hard Drives
- External PC Card Hard Drives
- Battery Maintenance and Storage
- Maintaining Batteries
- Storing Batteries
- Computer Maintenance and Storage
- Maintaining Your Computer
- Storing Your Computer
- Appendix A Error Messages
- Introduction
- POST Messages
- MS-DOS Messages
- Windows Messages
- Application Messages
- Appendix B Troubleshooting
- What to Try First
- For More Help
- Common Solutions to Common Problems
- Applications
- Batteries
- Cellular Modem
- Display
- Hard Disk
- I/O Ports
- Keyboard
- Landline Modems
- Miscellaneous
- Mouse
- PC Cards
- Pen/Touch Screen
- Wireless Modems
- Appendix C Glossary
- Index
106
GoBook Users Manual
77-0100-001 12 September 2000
external power.
• If the battery is new or has been stored for a week or more, follow this procedure:
1 Make sure the computer is turned off.
2 Open the battery door and remove the battery.
3 Connect the AC adapter to the computer and an AC wall outlet, and then turn on the computer by
pressing the Power button.
4 Reinstall the battery and replace the battery door.
5 Allow the system to remain idle for one hour with the AC adapter connected to the computer.
The Charging LED stays lit when the battery starts charging.
6 If the battery still fails to charge after an hour, remove the battery, wait several seconds, and then
install it again.
If the battery does not begin charging within several minutes, return the unit for service.