User Manual
Table Of Contents
- Contents
- Section 1 Getting Started
- Introduction
- Unpacking Your System
- Precautions
- Checklists
- Features
- The First Time. . .
- Installing the Battery
- Connecting the AC Adapter
- Turning the Computer On and Off
- Adjusting the Volume
- Calibrating the Touch Screen
- Startup Problems?
- Section 2 Getting Familiar with Your Computer
- Introduction
- Individual Parts
- LED Activity Indicators
- LED Power / Wireless Modem Indicators
- Keyboard Basics
- Restarting the Computer
- Primary Keys
- Arrow Keys
- Function Keys
- Numeric Keypad
- Touchpad
- General Guidelines
- Scrolling Buttons
- Connecting an External Keyboard or Mouse
- Disk Drives
- The PC Card Slot
- Connecting to an External Monitor
- Section 3 Making Connections
- Introduction
- Rear Connectors
- Left Side Connectors
- Right Side Connectors
- Section 4 If You Have a Wireless Modem
- Introduction
- Before You Start: Register!
- Registering Your Wireless Modem
- Wireless Modem LED Status
- Installing Your Wireless Modem Software
- Using Your Wireless Modem
- Section 5 Power Management
- Power Management
- Battery Calibration
- Monitoring Battery Power
- Low Battery Alarms
- Battery Charging
- Power Saving Modes
- Suspend Mode
- Initiating Suspend Mode
- Power Button Settings
- When to Replace the Battery
- Heat Considerations
- Section 6 Customizing Your Bios Settings
- Using the BIOS Setup Utility
- BIOS Setup Menu
- Starting the BIOS Setup Utility
- The Main Menu
- Navigating and Entering Information in BIOS
- Standard CMOS Setup
- Standard Feature Description
- Advanced CMOS Setup
- Power Management
- Peripheral Setup
- Auto-Detect Hard Disk
- Change Supervisor Password
- Change User Password
- Auto Configuration with Optimal Settings
- Exiting and Saving
- Section 7 Optional Equipment and Accessories
- Vehicle Adapter
- Vehicle Cradle
- PRECAUTIONS
- Charging Batteries
- Communicating with Other Devices
- Surge Protection
- Selecting the Right Surge Protection
- Selecting the Right Equipment
- Section 8 Maintenance and Storage
- Introduction
- Touch Screen Care
- Hard Drive Care and Handling
- Internal Hard Drives
- External PC Card Hard Drives
- Battery Maintenance and Storage
- Maintaining Batteries
- Storing Batteries
- Computer Maintenance and Storage
- Maintaining Your Computer
- Storing Your Computer
- Appendix A Error Messages
- Introduction
- POST Messages
- MS-DOS Messages
- Application Messages
- Appendix B Troubleshooting
- What to Try First
- For More Help
- Common Solutions to Common Problems
- Applications
- Batteries
- Display
- Hard Disk
- I/O Ports
- Keyboard
- Landline Modems
- Miscellaneous
- Mouse
- PC Cards
- Pen/Touch Screen
- Wireless Modems
- Appendix C Glossary
- Index
77
Section 7. Optional Equipment and Accessories
77-0100-003 19 January 2001
Communicating with Other Devices
Connect the external device to either of the USB ports on the back of the cradle, and then place the GoBook onto the
vehicle cradle. You can install or remove the computer from the vehicle cradle without connecting or disconnecting
the cables.
Important
• A temperature of 0ºC to +60ºC (32ºF to +140ºF) is recommended when
charging batteries with the vehicle cradle. Batteries may not charge
successfully outside this temperature range.
• If you charge your battery daily, rely on the gas gauge reading to determine
battery capacity. The gas gauge displayed by the Power Meter may show that
the battery is full, but charging continues. This happens becuase the charging
process is trying to put a little more capacity into the battery. External power
can be removed at this time since the battery is virtually full.
• If your battery is new or has not been used for several weeks, rely on the
indicator light to determine when the battery is fully charged. The gas gauge
is unreliable in these cases; it may read 100 percent, but the actual capacity is
only 10 percent.