User Manual

Table Of Contents
47
Section 4. If You Have a Radio Modem
77-0100-003 19 January 2001
RIM 802D (DataTac) for Motient
With the exception of the built-in diagnostic program of the RIM radio, there are no standard applications
shipped that allow the RIM 802D radio to be used for communication.
The RIM 802D radio understands two protocols: Native Control Language (NCL) and; RIM access protocol
(RAP). To use the RIM 802D radio, an application that uses one of these protocols must be installed on the computer
and configured to communicate on COM4.
RIM 902D (Mobitex) for Cingular
With the exception of the built-in diagnostic program of the RIM radio, there are no standard applications
shipped that allow the RIM 902M radio to be used for communication.
The RIM 902M radio understands two protocols: MASC, and; RIM access protocol (RAP). To use the RIM 902M
radio, an application that uses one of these protocols must be installed on the computer and configured to communi-
cate on COM4.
Lucent Wireless LAN
Go to your preferred LAN application and run normally
Cisco Wireless LAN
Go to your preferred LAN application and run normally
CAUTION While the radio is operating, its antenna must be at least 20 cm from
all persons in order to comply with the FCC RF exposure limit. Radio (wireless
modem) operators must make sure their radio unit is in compliance with these
FCC regulations. See Section 7 Optional Equipment and Accessories for
important information about vehicle-mounted antennas.