User's Manual

Electromagnetic Compatibility
CAUTION!
Approved accessories only may be used with this equipment. In general, all cables must be high quality,
shielded, correctly terminated and normally restricted to 2 meters in length. Itronix AC Adaptors employ
special provisions to avoid radio interference and should not be altered or substituted.
Unapproved modifications or operations beyond or in conflict with these instructions for use may void
authorization by the authorities to operate the equipment.
Europe
This product complies with the radio interference protection requirements of the Council Directive 89/336/EC
on the approximation of the laws of the Member States of the European Union relating to electromagnetic
compatibility. The product was tested in a typical configuration and found to conform to the following test
specifications:
EN55022 Radiated and conducted emissions, Class B.
EN50082 or EN55024 ESD and radiated and conducted immunity.
For further compliance details, refer to the specific CE Declaration Of Conformity. This is available on request,
please quote the exact and full model number for the product(s) in question.
USA
RADIO INTERFERENCE, FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Canada
English
This digital apparatus does not exceed class B limits for radio noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian Department of Communications, standard ICES-003.
Français
Avis de conformité aux normes du Ministère des Communications du Canada.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicable aux
appareils numériques de classe B préscrites dans le Règlement sur le brouillage radioélectrique édicté par le
Ministère des Communications du Canada, NMB-003.
26
Contents
The Other Guides 1
Setting Up 2
Fitting the battery pack 2
Switching the unit on 3
Calibrating the touch screen 3
Setting the time and date 4
Recording your personal information 4
Controls 4
How to use the pen 5
How to adjust the screen contrast 5
How to use the screen backlight 5
How to enter data 6
How to move the cursor 6
How to reset your Itronix fex21 7
Batteries 8
How to check the charge level of Li-Ion batteries 9
How to charge the battery 10
How to replace the battery pack 11
How to replace Alkaline batteries 12
Distribution and Battery management 12
Battery Storage 13
Looking after your fex21 14
Cleaning your fex21 14
Using your fex21 safely 15
Backstrap 15
CompactFlash and PC Cards 16
Using CompactFlash cards 16
Using Type II and Type III PC Cards 18
Using Wireless Communications 20
Peripherals 21
Troubleshooting 21
AC Power Adaptor 22
Additional instructions for the 12V dc power cable 22
Additional instructions for the 24V vehicle battery converter 23
Modem 24
European Modem Only (CTR21) 24
USA Modem Only (FCC part 68) 25
Electromagnetic Compatibility 26
i