User Manual

802.11g Wireless LAN+BT SiP combo Module V2.2
All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI
.
21
PRINTED WIRING BOARDS
: The printed wiring boards shall be Underwriters
Laboratories Inc. "Recognized Component" (ZPMV2) under the category for Printed
Wiring Boards, and shall be flammability rated 94V-1 or less flammable. The board
material shall be rated 130°C minimum.
CONNECTORS
: Any connectors, if used, shall be Underwriters Laboratories, Inc.
"Recognized" (ECBT2/RTRT2) in accordance with the requirements in the UL Standard
for Safety, UL 498. Any polymeric connector housing shall be molded of plastics rated
UL 94V-2 or less flammable when tested to UL 94.
WIRING
: Any wiring material, if used, shall be UL Recognized Component Appliance
Wiring Material (AVLV2). Wire shall be minimum rated 30V, 105°C.
PLASTIC PARTS
- Any plastic parts used shall be molded of plastics that are UL
"Recognized" (QFMZ2) and rated UL 94V-2 or less flammable when tested to UL 94.
“PB FREE”
- The entire component Suppliers has to support Green requirement base on
USI’s policy. All of the components which including process and materials has to be Lead
Free.
8.4. RADIO REQUIREMENTS AND APPROVALS
The WM-BG-MR-01 module is tested with adapter card to comply with following standard.
The testing is to assure the performance of regulatory requirement on module. Final
certification will be conducted on system level.
US/CAN: FCC CFR47 Part 15.247
Japan: TELEC
Korea: MIC
Europe: ETS 300-328 V1.6.1