User's Manual

Battery Conservation
To conserve power, the GoBook Q•100 automatically switches itself off (suspends) after 3 minutes of
inactivity when on battery power. It does not suspend when connected to AC power.
See Also
Battery Information
Checking the Batteries
Battery Charging
Battery Replacement
Battery Storage
Battery Charging
Use only the AC Adapter or vehicle charger supplied with your GoBook Q•100.
Plug the GoBook Q•100 charging adapter connector into the COM1 (left) socket of the GoBook Q•100.
Then connect the AC Adapter to a suitable AC mains power supply.
The battery pack may take up to three hours to fully recharge. Make sure that the pack is fully recharged
to 100% capacity so that the battery gauge calculations will be accurate.
The left green LED below the display flashes regularly while the battery is charging. When charging is
complete, the green LED stays lit. If the LED ever flashes irregularly, a charging error has occurred and
you should seek advice from your system provider.
See Also
Battery Information
Checking the Batteries
Battery Conservation
Battery Replacement
Battery Storage
Battery Replacement
CAUTION
Do not attempt to open, puncture or dispose of the battery pack in fire. The battery pack can
burst or explode releasing hazardous chemicals.
1. Turn off your GoBook Q•100.
2. Remove the hand strap by pulling the lower clip down and out of its recess.
3. Using a coin or flathead screwdriver, release the two battery retaining screws.
4. Remove the old battery pack using the flat end of the stylus as a lever, if necessary.
5. Fit the new battery pack in position and press down firmly.
6. Using a coin or flathead screwdriver, lock the battery retaining screws.
7. Refit the hand stra
p
.
Pa
g
e 5 of 14Q•100 Hel
p
28/08/2003file://C:\Documents%20and%20Settin
g
s\
j
onathan\Local%20Settin
g
s\Tem
p
\Q.100%20He...