User's Manual
NOTICE
The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal
Equipment Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be made by a representative designated by the supplier. Any repairs or alterations made
by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the
user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility , telephone lines, and
internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural
areas.
Europe
This product complies with the radio interference protection requirements of the Council Directive 89/336/EC on the
approximation of the laws of the Member States of the European Union relating to electromagnetic compatibility. The
product was tested in a typical configuration and found to conform to the following test specifications:
EN55022 Radiated and conducted emissions. Class B.
EN50082 or EN55024 ESD and radiated and conducted immunity.
For further compliance details, refer to the specific CE Declaration Of Conformity. This is available on request, please quote
the exact and full model number of the product(s) in question.
Warnings and Cautions CAUTION! Approved accessories only may be used with this equipment. In general, all cables
must be of high quality, shielded, correctly terminated and normally restricted to 2 metres in length. Itronix AC Adapters
employ special provisions to avoid radio interference and should not be altered or substituted.
Unapproved modifications or operations beyond or in conflict with these instructions for use may void authorization by the
authorities to operate this equipment.
WARNING It is important that only authorized Itronix personnel attempt repairs on Itronix equipment as this might void
any maintenance contract with your company. Unauthorized service personnel might be subject to shock hazard on some
Itronix equipment if removal of protective covers is attempted.
The product you have purchased is powered by a rechargeable battery. The battery is recyclable and, under various state and
local laws, it may be illegal to dispose of this battery into the municipal waste stream. Do not crush the battery or place it in a
fire. Check with your local solid-waste officials for details on recycling options or proper disposal.
CAUTION Internal components of the GoBook Q•100 computer will be damaged if exposed to contaminants. When dust
covers, the PC card door, or the bottom access panel are open on the computer, shield the unit from all contaminants such as
liquids, rain, snow, and dust.
CAUTION This device was evaluated for body-worn RF exposure compliance with carry case P/N: 54-0644-001. Use
only the approved carry case (P/N. 54-0644-001) or similar body-worn accessories that do not contain metallic components
and provide at least 0.5 cm separation between the device and the user's body.
Q
•
100 Help Legal
28/08/2003
file://C:\Documents%20and%20Settings\jonathan\Local%20Settings\Temp\Q.100%20He
...
The antenna location is fixed in the top right edge of the device and is not to be relocated.