User Manual

See Also
Battery Information
Checking the Batteries
Battery Charging
Battery Replacement
Battery Storage
Battery Charging
Use only the AC Adapter or vehicle charger supplied with your GoBook Q•100.
Plug the GoBook Q•100 charging adapter connector into the COM1 (left) socket of the
GoBook Q•100. Then connect the AC Adapter to a suitable AC mains power supply.
The battery pack may take up to three hours to fully recharge. Make sure that the pack is
fully recharged to 100% capacity so that the battery gauge calculations will be accurate.
The left green LED below the display flashes regularly while the battery is charging.
When charging is complete, the green LED stays lit. If the LED ever flashes irregularly, a
charging error has occurred and you should seek advice from your system provider.
See Also
Battery Information
Checking the Batteries
Battery Conservation
Battery Replacement
Battery Storage
Battery Replacement
CAUTION Do not attempt to open, puncture or dispose of the battery pack in fire. The
battery pack can burst or explode releasing hazardous chemicals.
1. Turn off your GoBook Q•100.
2. Remove the hand strap by pulling the lower clip down and out of its recess.
3. Using a coin or flathead screwdriver, release the two battery retaining screws.
4. Remove the old battery pack using the flat end of the stylus as a lever, if
necessary.