User's Manual
Table Of Contents
80-VK890-3 Rev. A 12
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Gobi2000 User Guide Standards and Regulatory Compliance
5. Installation of the Gobi2000 module into a host device can only be completed by authorized
personnel unless the FCC certification addresses FCC host/module authentication
requirements.
6. A label with the following statements must be attached to the host end product:
This device contains Tx FCC ID: J9CGOBI2000
This equipment contains equipment certified under IC: 2723A-GOBI2000
Other regional required regulatory markings
7. The host end product must include a user manual that clearly defines operating requirements
and conditions that must be observed to ensure compliance with current FCC/IC RF exposure
guidelines.
8. The host end product must also pass the FCC Part 15 unintentional emission testing
requirement and be properly authorized per FCC Part 15.
For portable devices, in addition to conditions 3 through 6 described above, a separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.