User's Manual

4-17
r
and show
g. m.
.
e display on the transceiver should now stop scanning and
4-2.2.8
1. Se n Figure 4-1. Connect the
NTER IN connector on the R2600 to Pin E (PT Out) of the
nd.
2.
3.
l for the preset-screen.
b. Use the CURSOR POSITION keys
to highlight preset 03.
er the CRT
0 keypad.
f.
h. to bandwidth and press the "NARROW 5 kHz" softkey.
'T CARE" softkey.
ct the "Tone
l. rsor to the DTMF Code position and press the "DON'T CARE" softkey.
" softkey to
m.
4. Perform the following steps to complete the setup on the R2600 analyzer.
l. Move the cursor to RF Control and press the "GEN"
m from the keypad.
d. on the R2600 panel. Move the cursor to the Synth
tion.
e. R
n depress the "Off" softkey.
f. Verify the DTMF position and the External position are both OFF.
f.
On the R2600, increase the RF Output Level with the TUNING control until the speake
unsquelches. The display on the transceiver should now stop scanning
Channel 8 (312 MHz).
Using the TUNING knob on the front panel adjust the RF Output Level to <-130 dB
Select preset channel 6
h. On the R2600, increase the RF Output Level with the TUNING control, until the
speaker unsquelches. Th
show Channel 6 (300.000 MHz).
Signal-Strength Meter
t up the test equipment as shown i
VERT/SINAD/DIST/DVM/COU
Remote connector. Pin A of the Remote connector is return grou
Set the input power supply to 28  .1 Vdc.
Preset the R2600 by performing the following steps.
a. Press the MEM (Memory) key on the R2600 pane
c. Press the "view preset" softkey. Note: The softkeys are the eight keys und
screen on the R2600.
d. Use the CURSOR POSITION keys to the Monitor Frequency position and enter
173.975 from the R260
e. Move the cursor to Modulation Type and press the "FM" softkey.
Move the cursor to the Generate Frequency position and enter 173.975 from the
R2600 keypad.
g. Move the cursor to Modulation Type and press the "FM" softkey.
Move the cursor
i. Move the cursor to the Duplex Offset position and press the "DON
j. Move the cursor to Synth. Format Sel (synthesizer format select) and sele
A" softkey.
k. Move the cursor to Freq (frequency) and enter 01000.0 from the keypad.
Move the cu
Note: The "more" softkey may have to be depressed for the "DON'T CARE
be displayed.
Press the "return" softkey twice.
a. Press RF key on the R2600 pane
softkey.
b. Move the cursor to the Output Lvl (RF Output Level) position and enter a level of -
130.0 dB
c. Move the cursor to the Gen RF Out position and press the "RF IN/OUT" softkey.
Depress the AUD (Audio) key
(Synthesizer) position and enter 6.50 kHz from the keypad. Note: This is FM devia
Depress the RIGHT ARROW CURSOR CONTROL key and depress the "Cont"
(Continuous) softkey.
Move the cursor to the Fixed 1 kHz position. Depress the LEFT ARROW CURSO
CONTROL key and the