User's Manual

4-16
f.
g. play) key on the R2600 panel. Move the cursor to the Meter
o
layed.
ftkey.
j.
s" softkey.
y to be
n. cursor to the Vert (Vertical) position and depress the "1 V" softkey. Note: The
o.
eys as appropriate to center the displayed scope screen trace. Note: The
m
5. Se
the transceiver.
e preset frequencies as listed in Table 4-3. Adjust
N, BCN OFF, SPKR ON, CH 8
6. Sc
a. On the R2600 fro e Output Lvl (RF
vel to <-130 dBm.
ckwise until the speaker just squelches. Adjust the
FT
L keys to position the cursor on the RF Output Level's
c.
d.
e. wise until speaker squelches. After approximately 8 seconds,
Verify the DTMF position and the External position are both OFF.
Depress the DISP (Dis
position and depress the "AC VOLTS" softkey. Note: The "more" softkey may have t
be depressed for the "AC VOLTS" softkey to be disp
h. Move the cursor to the Range position and depress the "AUTO" so
i. Move the cursor to the Display position and depress the "EXT SCOPE" softkey.
Move the cursor to the Coupling position and depress the "AC" softkey.
k. Move the cursor to the Trigger position and depress the "AUTO" softkey.
l. Move the cursor to the Trigger Lvl (Trigger Level) position and enter 500 from the
keypad.
m. Move the cursor to the Horiz (Horizontal) position and depress the "500 u
Note: The "more" softkey may have to be depressed for the "500 us" softke
displayed.
Move the
"more" softkey may have to be depressed for the "1 V" softkey to be displayed.
Move the cursor to the Pos (Position) position and depress the "move up" or "move
down" softk
TUNING knob on the R2600 panel may be used in lieu of the "move up" or "move
down" softkeys.
p. Adjust both the SQUELCH and VOLUME controls on the front panel to their maximu
CCW positions.
tup the URC-200 (V2) as follows:
a. Turn the transceiver on and note the input current. It should be approximately 240mA.
If the current exceeds 330mA, a problem exists in the transceiver. Turn off the power
and troubleshoot
b. Set the channels 6, 7, and 8 for th
the URC-200 (V2) for the following. Note: Information on presetting the URC-200 (V2)
is given in Paragraph 2-3.2 located in Section 2 of this manual.
FM, PT, SCN O
c. Adjust the SQ (Squelch) control fully counter-clockwise, past its detent, to the OFF
position.
an Function Measurements:
nt panel depress the RF key. Move the cursor to th
Output Level) position. Using the TUNING knob on the front panel adjust the RF
Output Le
b. Adjust the Squelch control clo
TUNING knob which is adjusting the RF Output Level clockwise until the speaker just
unsquelches. Note: The TUNING knob's resolution may have to be adjusted so it is
controlling tenths of a dB of RF Output Level. To do this depress the RIGHT or LE
ARROW CURSOR CONTRO
tenth of a dB position.
Set the transceiver to SCAN channels 6 through 8 as described in Paragraph 2-3.2.7
of Section 2.
Turn SCN ON as described in Paragraph 2-3.3.1 of Section 2.
Adjust SQ control clock
the display should show that channels 6 through 8 are being scanned.