User's Manual

4-14
l. Move the cursor to RF Control and press the "GEN"
d. on the R2600 panel. Move the cursor to the Synth
tion.
e.
g. . Move the cursor to the Meter
oftkey may have to
i. T SCOPE" softkey.
from the
.
.
e
e
p.
5.
a. iver on and note the input current. It should be approximately 240mA.
roblem exists in the transceiver. Turn off the power
-
formation on presetting the URC-200 (V2) is given in
c. e, past its detent, to the OFF
position.
6.
a. On the R2600 front panel depress the RF key. Move the cursor to the Output Lvl (RF
NING knob on the front panel adjust the RF Output
a. Press RF key on the R2600 pane
softkey.
b. Move the cursor to the Output Lvl (RF Output Level) position and enter a level of -
080.0 dBm from the keypad.
c. Move the cursor to the Gen RF Out position and press the "RF IN/OUT" softkey.
Depress the AUD (Audio) key
(Synthesizer) position and enter 6.50 kHz from the keypad. Note: This is FM devia
Depress the RIGHT ARROW CURSOR CONTROL key and depress the "Cont"
(Continuous) softkey.
Move the cursor to the Fixed 1 kHz position. Depress the LEFT ARROW CURSOR
CONTROL key and then depress the "Off" softkey.
f. Verify the DTMF position and the External position are both OFF.
Depress the DISP (Display) key on the R2600 panel
position and depress the "AC VOLTS" softkey. Note: The "more" s
be depressed for the "AC VOLTS" softkey to be displayed.
h. Move the cursor to the Range position and depress the "AUTO" softkey.
Move the cursor to the Display position and depress the "EX
j. Move the cursor to the Coupling position and depress the "AC" softkey.
k. Move the cursor to the Trigger position and depress the "AUTO" softkey.
l. Move the cursor to the Trigger Lvl (Trigger Level) position and enter 500
keypad.
m. Move the cursor to the Horiz (Horizontal) position and depress the "500 us" softkey
Note: The "more" softkey may have to be depressed for the "500 us" softkey to be
displayed
n. Move the cursor to the Vert (Vertical) position and depress the "1 V" softkey. Note: Th
"more" softkey may have to be depressed for the "1 V" softkey to be displayed.
o. Move the cursor to the Pos (Position) position and depress the "move up" or "move
down" softkeys as appropriate to center the displayed scope screen trace. Note: The
TUNING knob on the R2600 panel may be used in lieu of the "move up" or "mov
down" softkeys.
Adjust both the SQUELCH and VOLUME controls on the front panel to their maximum
CCW positions.
Setup the URC-200 (V2) as follows:
Turn the transce
If the current exceeds 330mA, a p
and troubleshoot the transceiver.
b. Adjust the URC-200 (V2) for preset channel 8. On the URC-200 (V2) set the
frequency to the preset frequency as listed in Table 4-3 for channel 8. Adjust the URC
200 (V2) for the following. Note: In
Paragraph 2-3.2 located in Section 2 of this manual.
FM, PT, SCN OFF, BCN OFF, SPKR ON
Adjust the SQ (Squelch) control fully counter-clockwis
Squelch Sensitivity Measurements:
Output Level) position. Using the TU
Level to <-130 dBm.