User's Manual

4-12
4.
a. n the R2600 panel. Move the cursor to RF Control and press the "GEN"
b. Move the cursor to the Output Lvl (RF Output Level) position and enter a level of -
d. the AUD (Audio) key on the R2600 panel. Move the cursor to the Synth
5.6
e: This is FM deviation. Depress the RIGHT ARROW
f.
g. the Meter
o
layed.
ftkey.
j.
s" softkey.
y to be
n. cursor to the Vert (Vertical) position and depress the "10 V" softkey. Note:
o.
eys as appropriate to center the displayed scope screen trace. Note: The
m
5. Se
the transceiver.
t channel 8. On the URC-200 (V2) set the
6. CT
a.
m. Press the "return" softkey twice.
Perform the following steps to complete the setup on the R2600 analyzer.
Press RF key o
softkey.
080.0 dBm from the keypad.
c. Move the cursor to the Gen RF Out position and press the "RF IN/OUT" softkey.
Depress
(Synthesizer) position and from the keypad enter 5.00 kHz for VHF frequencies or
kHz for UHF frequencies. Not
CURSOR CONTROL key and depress the "Cont" (Continuous) softkey.
e. Move the cursor to the Fixed 1 kHz position. Depress the LEFT ARROW CURSOR
CONTROL key and then depress the "Off" softkey.
Verify the DTMF position and the External position are both OFF.
Depress the DISP (Display) key on the R2600 panel. Move the cursor to
position and depress the "AC VOLTS" softkey. Note: The "more" softkey may have t
be depressed for the "AC VOLTS" softkey to be disp
h. Move the cursor to the Range position and depress the "AUTO" so
i. Move the cursor to the Display position and depress the "EXT SCOPE" softkey.
Move the cursor to the Coupling position and depress the "DC" softkey.
k. Move the cursor to the Trigger position and depress the "AUTO" softkey.
l. Move the cursor to the Trigger Lvl (Trigger Level) position and enter 500 from the
keypad.
m. Move the cursor to the Horiz (Horizontal) position and depress the "500 u
Note: The "more" softkey may have to be depressed for the "500 us" softke
displayed.
Move the
The "more" softkey may have to be depressed for the "10 V" softkey to be displayed.
Move the cursor to the Pos (Position) position and depress the "move up" or "move
down" softk
TUNING knob on the R2600 panel may be used in lieu of the "move up" or "move
down" softkeys.
p. Adjust both the SQUELCH and VOLUME controls on the front panel to their maximu
CCW positions.
tup the URC-200 (V2) as follows:
a. Turn the transceiver on and note the input current. It should be approximately 240mA.
If the current exceeds 330mA, a problem exists in the transceiver. Turn off the power
and troubleshoot
b. Adjust the URC-200 (V2) for prese
frequency to the preset frequency as listed in Table 4-3 for channel 8. Adjust the URC-
200 (V2) for the following. Note: Information on presetting the URC-200 (V2) is given in
Paragraph 2-3.2 located in Section 2 of this manual.
FM, CT, SCN OFF, BCN OFF,
Audio Response Measurement (1 kHz):
Note amplitude of the waveform in Vpp.