User's Manual

4-10
'T CARE" softkey.
one
eypad.
softkey.
program the frequency presets in steps D and E above.
4. Pe
a. n the R2600 panel. Move the cursor to RF Control and press the "GEN"
b. r a level of -
.
" softkey.
the RIGHT ARROW CURSOR CONTROL key and depress the "Cont"
e. kHz position. Depress the LEFT ARROW CURSOR
g.
e to
C VOLTS" softkey to be displayed.
PE" softkey.
k.
l. nd enter 50 from the
y.
ey to be
y. Note: The
o. cursor to the Pos (Position) position and depress the "move up" or "move
e
eys.
5.
i. Move the cursor to the Duplex Offset position and press the "DON
j. Move the cursor to Synth. Format Sel (synthesizer format select) and select the "T
B" softkey.
k. Move the cursor to Freq (frequency) and enter 08000.0 from the k
l Move the cursor to the DTMF Code position and press the "DON'T CARE"
Note: The "more" softkey may have to be depressed for the "DON'T CARE" softkey to
be displayed.
m. Press the "return" softkey. Repeat steps A through K for presets 02 through 10. Use
Table 4-4 to
n. Press the "return" softkey.
rform the following steps to complete the setup on the R2600 analyzer.
Press RF key o
softkey.
Move the cursor to the Output Lvl (RF Output Level) position and ente
050.0 dBm from the keypad
c. Move the cursor to the Gen RF Out position and press the "RF IN/OUT
d. Depress the AUD (Audio) key on the R2600 panel. Move the cursor to the Synth
(Synthesizer) position and enter 70% from the keypad. Note: This is AM modulation.
Depress
(Continuous) softkey.
Move the cursor to the Fixed 1
CONTROL key and then depress the "Off" softkey.
f. Verify the DTMF position and the External position are both OFF.
Depress the DISP (Display) key on the R2600 panel. Move the cursor to the Meter
position and depress the "AC VOLTS" softkey. Note: The "more" softkey may hav
be depressed for the "A
h. Move the cursor to the Range position and depress the "AUTO" softkey.
i. Move the cursor to the Display position and depress the "EXT SCO
j. Move the cursor to the Coupling position and depress the "AC" softkey.
Move the cursor to the Trigger position and depress the "AUTO" softkey.
Move the cursor to the Trigger Lvl (Trigger Level) position a
keypad.
m. Move the cursor to the Horiz (Horizontal) position and depress the "50 us" softke
Note: The "more" softkey may have to be depressed for the "50 us" softk
displayed.
n. Move the cursor to the Vert (Vertical) position and depress the "5 V" softke
"more" softkey may have to be depressed for the "5 V" softkey to be displayed.
Move the
down" softkeys as appropriate to center the displayed scope screen trace. Note: Th
TUNING knob on the R2600 panel may be used in lieu of the "move up" or "move
down" softk
p. Adjust both the SQUELCH and VOLUME controls on the front panel to their maximum
CCW positions.
Setup the URC-200 (V2) as follows: