User's Manual

3-16
Table 3-5. Transceiver Status Inquiry Commands
CODE NAME DESCRIPTION
?10 Current Preset Status Gives status of the various values of the current preset.
"Txxxxxxx" = Transmit Frequency
"Rxxxxxxx" = Receive Frequency
"Mx" – AM/FM – TRANSMIT/RECEIVE
“M0” = TRANSMIT/RECEIVE AM
“M1” = TRANSMIT/RECEIVE FM
"Nx" – AM/FM – TRANSMIT only
“N0” = TRANSMIT AM
“N1” = TRANSMIT FM
"Cx" – SCAN LIST ON/OFF
“C0” = Not on scan list
“C1” = On scan list
"Px" – PRESET NUMBER
"#x" – Power Level
“#0” = Lo Power
“#1” = Med Power
“#2” = High Power
?11 General Status
Gives the general status of the transceiver in the form : “XxJjLldyFfvzzz”
"Xx" – PT/CT
“X0” = PT
“X1” = CT
"Jx" – SPEAKER OFF/ON
“J0” = Speaker OFF
“J1” = Speaker ON
"Lx" – LAMP OFF/LO/MED/HI
“L0” = Lamp Off
“L1” = Lamp Lo
“L2” = Lamp Med
“L3” = Lamp Hi
"dx" – Option Status
"d0" - no options
"d1" - PL option selected
"d2" - 30_90 option selected
"d3" - both PL and 30_90 option selected
"d4" - 420 option selected
"d5" - both PL and 420 option selected
"d6" - both 30_90 and 420 option selected
"d7" - all three options selected
"Fx" – Overtemp Condition
“F0” - Temperature OK
“F1” - Overtemp Condition
zzz = 000 if no options are selected
= 001 to 255 depending on the options enabled (see the ‘d’ cmd..
?12 General Mode Status Gives the mode of the transceiver with one of the codes shown below. This
will indicate whether it is in the Beacon, normal receive, or transmit mode.
"*1" = Beacon mode
"U0" = Receive mode
"U1" = Transmit mode
?13 Squelch Status "[0" = Transceiver Squelched
"[1" = Transceiver Squelch Broken
?14 Warp Value Returns the current warp value in the following format:
"Wxxx"
where:
‘W’ = Warp and
'xxx' = the current Warp value