User's Manual

3-14
Table 3-4. Transceiver Customizing Codes
CODE NAME DESCRIPTION
e Transceiver’s Internal
Speaker
The “e” Command followed by the appropriate two decimal digits will set
the state of the transceiver’s internal speaker upon turn ON of the
transceiver.
“e00” = Speaker is OFF at transceiver turn ON (default)
“e01” = Speaker is ON at transceiver turn ON
Transceiver’s Front
Panel Backlighting
The “e” Command followed by the appropriate two decimal digits will set
the intensity of the backlighting on the transceiver’s front panel keyboard
and display upon turn ON of the transceiver.
“e10” = Backlighting OFF (default)
“e11” = Backlighting at intensity level 1 (low)
“e12” = Backlighting at intensity level 2 (medium)
“e13” = Backlighting at intensity level 3 (high)
q Squelch Control
when in the CT mode
The “q” Command followed by the appropriate three decimal digits will set
the state of the CT squelch.
“q020” = CT squelch is always broken. The Squelch Control has no effect.
(default)
“q021” = CT squelch is broken by the signal level as controlled by the
Squelch Control.
Notes:
1. The Squelch Control can be either the front panel SQUELCH Control
or the remote squelch as controlled by the “$xxx” command.
2. PT squelch is unaffected by the “qxxx” command.
Scan Control
The “q” Command followed by the appropriate three decimal digits will set
the state of the Scan function.
“q030” = Scanning stops upon completion of a transmission. (default)
“q031” = Scanning resumes upon a completion of a transmission.
^
Delay and Timing
Parameters
xx = 00 to 01 yyy = 000 to 255. xx = device number yyy = device value
Device descriptions:
00: DVI Shutdown Time (Obsolete)
01: PTT Check Squelch Delay
Specifies the amount of time In 10 ms units) to wait before checking
squelch after entering receive mode following a PTT release. Example:
^01060 sets delay to 600 msecs.
!
Aviation Mode
Initializes all channels to the default values including Aviation Mode
On(AM, PT, low power, 225 MHz, Wideband 25 kHz, Aviation Mode On).
<
Wideband vs.
Narrowband selection
<1: Enable Wideband Filter If “833 authorized” option is enabled.
<2: Enable Narrowband Filter If “833 authorized” option is enabled. Returns
a NAK if “833 authorized” option is not enabled.