User's Manual

Fortress ES-Series CLI Guide: System and Network Monitoring
193
6.5 FastPath Mesh Monitoring
When bridging is set to FastPath Mesh (Section 3.2.2), the
Mesh Point CLI provides
show mesh commands to view an
array of information on the configuration, composition and
operation of the FP Mesh network.
6.5.1 FastPath Mesh Bridging Configuration
View the current FP Mesh settings with the show mesh
command:
# show mesh
Mesh is enabled
RFC 4193 ULA: FD00:0:8895:8895:214:8CFF:FEF8:18C0
Subnet Id: 0x8895
Mesh Transmit Control: auto
Mesh Reactivity: most
Mesh Time to Live: 4
Mesh Multicast RSSI clamp: off
Mesh Multicast rate clamp: off
Mesh Multicast Mode: auto
Mesh Control Packet Interval: auto
The Transmit Control setting is covered in Section 3.2.3.3.
The
Reactivity control is covered in Section 3.2.3.5. The
Time to Live control is covered in Section 3.2.3.6. Multicast
clamping thresholds are covered in Section 3.2.3.4, and
Multicast Mode in Section 3.2.3.1. The Control Packet
Interval
control is covered in Section 3.2.3.2.
Use the other show mesh commands to view specific FP Mesh
network information described in Table 6.1.
Table 6.1 Show Mesh Commands
Show Mesh Commands Description
show mesh -forwarding-table
-mac <
MacAddr >|-ip < IpAddr >|-name < HostName >
Displays which FastPath Mesh Point is forwarding traffic
for a particular MAC address. The MAC address can
belong to the FPMP itself, another FPMP node, or a
Non-Mesh Point (NMP): a host, client, Trusted Device,
etc., behind the FastPath Mesh Point.
show mesh -interfaces -verbose
Displays a list of FP Mesh interfaces, including the inter-
face name, type, current status, and the reason for the
current status. Use the -verbose switch to view all the
available details for each interface.