User's Manual

- 3 -

Step 1. Install Client Software and USB Stick Modem Drivers

Follow the instructions according to your installed operating system. Where no CD is provided for

installation, your service provider shall provide the client installation software and necessary drivers.

Windows 2000™

You must log in with administrative privileges

1. Where a CD is provided for the installation, close any programs that may be running and

insert the CD into the CD-ROM drive on your computer. If the CD does not autorun and display a start

screen, select Start->Run and enter d:\Setup.exe where d is your CD-ROM drive letter.

2. The Installation Setup Wizard will then prompt you through each step of the installation. (Use the

Next> and <Back buttons to navigate the wizard and click Finish on the final screen).

3. When you reach the License Agreement screen, the installation will not proceed further unless

you accept the terms of the License Agreement.

4. The installation software will then copy the Client Software and USB Stick Modem driver files

onto your computer from the installation CD.

5. When the transfer of files to the computer is complete, you will be asked to plug the USB Stick

Modem into your computer.

Windows Vista™, Windows XP™

You must log in with administrative privileges

1. Close any programs that may be running and insert the CD into the CD-ROM drive on your

computer. If the CD does not autorun and display a start screen, select Start->Run and enter

d:\Setup.exe where d is your CD-ROM drive letter.