User's Manual
- 2 -
Getting Started
This Quick Start Guide gives basic installation and configuration instructions. Follow the instructions on the
following pages to install the USB Stick Modem client software and driver files, before connecting the
modem to the computer and then perform on-line registration, if applicable.
Refer to the User Guide for the complete installation, upgrade and configuration procedures.
Be sure to complete each of the following steps outlined below before moving on to the next step.
SIM Card (if required)
You have been supplied with a username and password to be used when connecting to the TDD
network.
The SIM may not always be required when authenticating TDD networks, check with your service
provider.
The SIM card is inserted directly into the modem below the USB connector, there is no SIM tray.
Before removing the SIM card from the Modem, it is good practice and recommended that a safe
hardware removal procedure is always followed for the Modem device. Disconnect and close the
Client Software application.
To remove the USB Stick Modem, first locate the “Safely Remove Hardware” icon, shown above, from
the notification area usually to the right of the task bar. Using the mouse, left click on the icon. A
“Safely remove …” notification will be displayed similar to the one below. Click on the IPWireless
Network Adapter to safely power off the adapter. Note: If the modem is in use i.e. connected to a
network or the Client Software is open and displaying status, you will see a notification informing you
that it is not possible to remove the adapter. Ensure that the Client Software is disconnected and
closed before a safe removal.
To connect to the TDD network you must first enter your username and password details in the Client
Software using the Change User Details button near the bottom of the Application.
When connected the Client Software will minimize to the notification bar next to the clock. The
application can be restored by double clicking on this icon shown below.