User's Manual

ManualsBrandsGeneral Dynamics Broadband ManualsElectronicsUSB Modem

Wireless Broadband Modem

USB-Stick-Modem Quick Start Guide

Important Notes

Run the installation CD-ROM provided before connecting the USB Stick Modem to the

computer. The installation software will instruct the user when to insert the USB-Modem into the

computer If you wish to disconnect the USB Stick Modem from the computer card it is important

to first make it safe for removal. Do this by clicking on the icon in the toolbar on the lower right

of the screen and selecting STOP.

Caution:

This USB modem is approved for use in normal size laptop computers only (typically with 12

inch or larger display screens). To comply with FCC RF exposure requirements, this modem

should not be used in configurations that cannot maintain a distance of at least 5mm

(approximately 0.2 inch) from users and bystanders.

Antenna

(

internal

)

Status Indicator

SIM Card Tray

(beneath USB Connector - if fitted)

USB

Connector

(Cap removed)

Summary of content (9 pages)

PAGE 1
Wireless Broadband Modem USB-Stick-Modem Quick Start Guide Antennas (internal) USB Connector (Cap removed) Status Indicator SIM Card Tray (beneath USB Connector - if fitted) Important Notes: Run the installation CD-ROM provided before connecting the USB Stick Modem to the computer. The installation software will instruct the user when to insert the USB-Modem into the computer If you wish to disconnect the USB Stick Modem from the computer card it is important to first make it safe for removal.
PAGE 2
Getting Started This Quick Start Guide gives basic installation and configuration instructions. Follow the instructions on the following pages to install the USB Stick Modem client software and driver files, before connecting the modem to the computer and then perform on-line registration. Refer to the User Guide on the installation CD-ROM for the complete installation, upgrade and configuration procedures. Be sure to complete each of the following steps outlined below before moving on to the next step.
PAGE 3
Step 1. Install Client Software and USB Stick Modem Drivers Follow the instructions according to your installed operating system. Windows 2000™ You must log in with administrative privileges 1. Close any programs that may be running and insert the CD into the CD-ROM drive on your computer. If the CD does not autorun and display a start screen, select Start->Run and enter d:\Setup.exe where d is your CD-ROM drive letter. 2.
PAGE 4
Step 2. Insert the USB Stick Modem and Obtain the Best Radio Signal Fit the SIM or USIM card, where one has been provided, into the SIM slot in the USB Stick Modem, observing the correct orientation and with the gold contacts on the SIM/USIM face down. Connnect the USB Stick Modem into a USB port on your computer either directly or using the cable supplied. The modem will draw power from the computer that it needs in order to operate.
PAGE 5
Step 4. Updating Operating System Patches and TCP Settings The installation software will now determine if your computer needs any official operating system patches applied or any TCP configuration settings changed. Follow the instructions on each screen to complete the upgrading of any patches or TCP settings. Step 5.Your installation is now complete The installation has completed. You will be asked to reboot your computer so that any operating system patches and TCP setting changes can be used.
PAGE 6
Additional Information The no entry icon may be seen in the Signal Quality graph while the modem is searching for a signal. This behavior is expected. When only the red LED is lit it may not be possible to open the Client Software application. Safety and Care Instructions Before using your USB Stick Modem for the first time, please read and follow all warnings, safety, care, cleaning and operating instructions on the USB Stick Modem label and in this guide.
PAGE 7
Do not leave the USB Stick Modem in a motor vehicle parked in direct sunlight for more than fifteen minutes. Do not expose the USB Stick Modem to open flames. Do not modify the antenna or substitute any other antenna. Doing so may result in product failure and possible exposure to unsafe levels of RF. Switch your USB Stick Modem off when near medical equipment, fuel, chemicals, a potentially explosive atmosphere such as a gasoline station, or when in an area in which blasting is in progress.
PAGE 8
If you use the modem in accordance with these guidelines, the level of RF exposure will fall within the guidelines and the standards previously identified. FCC Interference Statement 15.19 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions. (1) (2) This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
PAGE 9
Care and Cleaning Guidelines Use a clean soft cloth, slightly moistened with water, and wipe the outside surface of the USB Stick Modem only. Do not use aerosol sprays, solvents, or abrasives when cleaning your USB Stick Modem. These items may scratch the surface or damage the interior components of the USB Stick Modem. Avoid dropping, shaking or striking the USB Stick Modem. This may damage its components. Information in this document and the products described are subject to change without notice.