User's Manual

P1D Wireless Broadband Modem User Manual
- Page 6 of 46 -
Do not expose the P1D Modem to open flames.
Switch your P1D Modem off when near medical equipment, fuel, chemicals, a potentially
explosive atmosphere such as a gasoline station, or when in an area in which blasting is in
progress. Also, switch it off before boarding an aircraft. Follow any other rules, regulations, or
posted notices that apply to the use of electronic or radio equipment.
Before using the P1D Modem near a pacemaker or similar device, consult a physician or the
device manufacturer for more information. In any event, do not use the P1D Modem within 8"
(20 cm) of a pacemaker or similar device.
Do not use the P1D Modem when you need to pay attention to other activities. For example,
never use it while driving or while supervising or operating machinery.
The P1D Modem, like any other wireless communications device, cannot guarantee a
connection in all circumstances. Do not rely on it for matters where a connection is essential.
Exposure to Radio Frequency Signals
The following information includes important safety guidelines regarding exposure to radio
frequency (RF) signals and the use of electronic devices as determined by the Federal
Communications Commission (FCC).
Your P1D modem is a low power radio transmitter and receiver. When it is ON, it receives and
also sends out RF signals. The FCC has adopted RF exposure guidelines with safety levels for
wireless cellular devices. The FCC guidelines are consistent with the safety standards
previously set by the U.S. and international standards bodies: American National Standards
Institute - ANSI C95.1 (1992); National Council on Radiation and Measurements - NCRP
Report 86 (1986); International Commission on Non-Ionizing Radiation Protection - ICNIRP
(1996). If you use the modem in accordance with these guidelines, the level of RF exposure
will fall within the FCC guidelines and the standards previously identified.
To comply with the FCC RF exposure rules, the P1D modem has been evaluated against the
Maximum Permissible Exposure (MPE) limits defined in Section 1.1310 of the FCC rules for
the uncontrolled environment. During normal operation, the modem should be kept a minimum
distance of 20cm (8 inches) away from the user and other persons to ensure compliance with
the MPE limits.
Care and Cleaning Guidelines
Use a clean soft cloth, slightly moistened with water, and wipe the outside surface of the
Modem only.
Do not use aerosol sprays, solvents, or abrasives when cleaning your P1D Modem. These
items may scratch the surface or damage the interior components of the Modem.
To avoid the risk of damage, always switch off P1D Modem and unplug the AC power adapter
from the wall power socket before cleaning them.